Coefficients/Potentiometers

Coefficients and assigned potentiometers are on different places on the board and put here together only for visualization.

Coefficients are quantitative parameters that enter analog computations in a multiplicative fashion. The Analog Thing features eight coefficient potentiometers, allowing the use of up to eight coefficients in an analog computation. Using the potentiometers, each coefficient can be set to any value between 0 and +1. An input to a coefficient potentiometer is multiplied by the value the coefficient potentiometer is set to such that their output is given by output = coefficient * input.

Five sections of the THAT user interface relate to the use of coefficient potentiometers, as shown in Figure 1:

• the COEFF section: these are inputs and output sockets
• the potentiometer section
• the MODE selector
• the COEFFICIENT selector
• the digital voltmeter

To familiarize yourself with the use of coefficient potentiometers, follow these steps:

1. Set the MODE selector to position COEFF.
2. Set the COEFFICIENT selector to position 1.
3. Use a patch cable to connect one of the +1 output jacks in the -1 / +1 section to the input (circle) associated with potentiometer COEFF 1 in the COEFF section.
4. Change the position of the COEFF 1 knob in the potentiometer section and observe the value displayed on the digital voltmeter. The displayed value is available at the output (triangle) associated with potentiometer COEFF 1 in the COEFF section.
5. Remove the patch cable plug from the +1 output jack in the -1 / +1 section and plug it into one of the -1 output jacks in in the -1 / +1 section.
6. Again, change the position of the COEFF 1 knob in the potentiometer section and observe the value displayed on the digital voltmeter.
7. Set the COEFFICIENT selector to any one of the other potentiometers (say, 4).
8. Use a patch cable to connect either of the -1 jacks in the -1 / +1 section with the input (circle) associated with the with the coefficient potentiometer you have chosen using the COEFFICIENT selector (say, 4).
9. Change the position of the COEFF knob associated with the coefficient you have chosen using the COEFFICIENT selector (say, 4) and observe the value displayed on the digital voltmeter.

Figure 1: Five sections of the THAT user interface relate to the use of coefficient potentiometers